RX-7 86-92 Coil Trailing Connector Set (Spec B) Deutsch DTM USB to CAN Cable is

USB to CAN Cable is used to communicate between your PC and the ECUMaster PMU

25 thread for direct replacement of the stock closed element sensor of the 93+ Mazda RX-7

No drilling/tapping required

Kit includes 10mm x 1

Broadband knock sensors provide full spectrum ability for knock sensing on a wide variety of engines

RX-7 86-92 Coil Trailing Connector Set (Spec B) Deutsch DTM USB to CAN Cable isConnector set for use with the stock trailing coils of the 86 92 RX 7 as well as the 13B RE Cosmo. We have not been able to source the exact matching two pin connector hardshells for the coils, so we use these connector sets to 1) replace the hardshell on the coil itself, and 2) install the new mating connector on the wire harness. These hardshells use the exact same terminals as the stock coils, so you simply depin the existing hardshell and slide